📦Image preparing
No Domestic Stock
Request a quote for this part and sellers will provide prices.
Key Specs Summary(12)
- features
- Enable control;Over Current Protection;Thermal Shutdown
- Number Of Outputs
- 1
- Operating Temperature
- -40℃~+125℃@(Ta)
- Operating Voltage
- 5.5V
- Output Configuration
- Positive
- Output CurrentVerified
- 600mA
- Output Type
- Fixed
- Output VoltageVerified
- 2.5V
- package
- LFCSP-8(3x3)
- Supply Current Iq
- 4mA
- Pin CountEnriched
- 8
- Package Industry NameEnriched
- LFCSP
Datasheet Extracted
Facts extracted directly from the datasheet (sourced)Pin Configuration · 8-Lead LFCSP · 8 pins
| # | Name | Type | Function |
|---|---|---|---|
| 1 | VREG | power out | Regulated Input Supply Voltage to LDO Amplifier. Bypass VREG to GND with a 10 µF or greater capacitor. |
| 2 | VOUT | power out | Regulated Output Voltage. Bypass VOUT to GND with a 10 µF or greater capacitor. |
| 3 | BYP | passive | Low Noise Bypass Capacitor. Connect a 1 µF capacitor from the BYP pin to GND to reduce noise. Do not connect a load to g |
| 4 | GND | power in | Ground Connection. |
| 5 | REF_SENSE | input | Reference Sense. Connect Pin 5 to the REF pin. Do not connect Pin 5 to VOUT or GND. |
| 6 | REF | output | Low Noise Reference Voltage Output. Bypass REF to GND with a 1 µF capacitor. Short REF_SENSE to REF for fixed output vol |
| 7 | EN | input | Enable. Drive EN high to turn on the regulator; drive EN low to turn off the regulator. For automatic startup, connect E |
| 8 | VIN | power in | Regulator Input Supply Voltage. Bypass VIN to GND with a 10 µF or greater capacitor. |
Absolute Maximum Ratings
| VIN to GND | -0.3 to +7V | |
| Storage Temperature Range | -65 to +150°C | |
| Junction Temperature | 150°C |
Recommended Operating
| Input voltage range | 2.3 to 5.5V | |
| Operating Ambient Temperature Range | -40 to +125°C |
Thermal
- theta ja
- 36.7
- theta jc
- 23.5
Ordering
- R7
- Tape and Reel
Similar Parts
Reference Designs Using This Part
0 designsManufacturer-validated system circuits with BOM and Gerber files — one step closer to a finished product than the typical circuit in a datasheet.